QA BEAMCHECKER™ PLUS 87
24 Customer Responsibility
This product and its components will perform properly and reliably only when operated and
maintained in accordance with the instructions contained in this manual and accompanying
labels. A defective device should not be used. Parts which may be broken or missing or are
clearly worn, distorted or contaminated should be replaced immediately with genuine
replacement parts manufactured by or made available from Standard Imaging Inc.
CAUTION: Federal law in the U.S.A. and Canadian law restrict the sale, distribution, or use of
this product to, by, or on the order of a licensed medical practitioner. The use of this product
should be restricted to the supervision of a qualified medical physicist.
CAUTION: As desired by IAEA, English is the default language for labeling and manuals. If
translated versions are available, resolve any differences in favor of the English versions.
WARNING: Measurement of high activity radioactive sources is potentially hazardous and
should be performed by qualified personnel.
WARNING: Proper use of this device depends on careful reading of all instructions and
labels.
WARNING: Where applicable, Standard Imaging products are designed to be used with the
versions of common radiation delivery devices, treatment planning systems and other
products or systems used in the delivery of ionizing radiation, available at the time the
Standard Imaging product is released. Standard Imaging does not assume responsibility,
liability and/or warrant against, problems with the use, reliability, safety or effectiveness that
arise due to the evolution, updates or changes to these products or systems in the future. It is
the responsibility of the customer or user to determine if the Standard Imaging product can
be properly used with these products or systems.
Should repair or replacement of this product become necessary after the warranty period, the
customer should seek advice from Standard Imaging Inc. prior to such repair or replacement.
If this product is in need of repair, it should not be used until all repairs have been made and
the product is functioning properly and ready for use. After repair, the product may need to
be calibrated. The owner of this product has sole responsibility for any malfunction resulting
from abuse, improper use or maintenance, or repair by anyone other than Standard Imaging
Inc.
Standard Imaging will make numerous and reasonable attempts to contact a customer
following completed manufacture or service of a product. Should a customer product remain
at Standard Imaging for more than 1 year following its completed manufacture or service,
Standard Imaging reserves the right to resell, restock, donate, discard or destroy the product.
The information in this manual is subject to change without notice. Please see
www.standardimaging.com for the latest information. No part of this manual may be copied
or reproduced in any form or by any means without prior written consent of Standard
Imaging Inc.
To Next Page
Loading...
Need help?
General
