Standard Imaging QA BEAMCHECKER PLUS User Manual

QA BEAMCHECKER™ PLUS 84
21 WARRANTY STATEMENT- 4424-16
Standard Imaging, Inc. sells this product under the warranty herein set forth. The warranty is
extended only to the buyer purchasing the product directly from Standard Imaging, Inc. or as
a new product from an authorized dealer or distributor of Standard Imaging, Inc.
For a period provided in the table below from the date of original delivery to the purchaser or a
distributor, this Standard Imaging, Inc. product, provided in the table, is warranted against
functional defects in design, materials and workmanship, provided it is properly operated
under conditions of normal use, and that repairs and replacements are made in accordance
herewith. The foregoing warranty shall not apply to normal wear and tear, or if the product
has been altered, disassembled or repaired other than by Standard Imaging, Inc. or if the
product has been subject to abuse, misuse, negligence or accident.
Product
Warranty Period
Standard Imaging Ionization Chambers
5 years
Standard Imaging Detectors
1 year
Standard Imaging Well Chambers
2 years
Standard Imaging Electrometers
5 years
Standard Imaging BeamChecker Products
2 years
Standard Imaging Software Products
1 year
All Other Standard Imaging Products
1 year
Standard Imaging Custom Products
1 year
Standard Imaging Remanufactured Products
180 days
Standard Imaging Custom Select Products
90 days
Consumables
90 days
Serviced Product
90 days (for service performed)
Resale Products
As defined by the Original Equipment Manufacturer
ADCL Product Calibration
(Standard Imaging uses the UW-ADCL for
recalibrations required under warranty, unless
otherwise requested)
0 - 90 days = 100% of ADCL Calibration Costs
91 - 182 days = 75% of ADCL Calibration Costs
183 – 365 days = 50% of ADCL Calibration Costs
366 – 639 days = 25% of ADCL Calibration Costs
(days from date of shipment to customer)
Standard Imaging’s sole and exclusive obligation and the purchaser’s sole and exclusive
remedy under the above warranties are, at Standard Imaging’s option, limited to repairing,
replacing free of charge or revising labeling and manual content on, a product: (1) which
contains a defect covered by the above warranties; (2) which are reported to Standard
Imaging, Inc. not later than seven (7) days after the expiration date of the warranty period in
the table; (3) which are returned to Standard Imaging, Inc. promptly after discovery of the
defect; and (4) which are found to be defective upon examination by Standard Imaging Inc.
All transportation charges (including customs, tariffs, duties and brokerage fees) are the
buyer’s responsibility. This warranty extends to every part of the product excluding
consumables (fuses, batteries, or glass breakage) or material reactions. Standard Imaging, Inc.
shall not be otherwise liable for any damages, including but not limited to, incidental

Standard Imaging QA BEAMCHECKER PLUS Specifications

General

Brand	Standard Imaging
Model	QA BEAMCHECKER PLUS
Category	Measuring Instruments
Language	English