Steca Tarom 4545 - 8 Menu Structure

12
DE
8 Menu structure
For the sake of clarity, only the s and ‘SET’ operating buttons are illustrated.
SET SET SET
SET SET SET
SET SET SET
SET SET SET
SET SET SET SET
SET SET
SET
SET
SET SET
Daily input
Daily load
Information
Load current Clear event log
Event log
Battery type
5)
Time format
Date format
Status display Main menu
Basic setting
Battery voltage
Output settings
Internal data
logger
Charge /
discharge
current
Battery
settings
Battery
capacity
Charge voltage 6)
Contrast
2)
SD card
Date
Time / date
Clear log data
4)
Battery control
mode
Equalisation
cycle
Time
Language
Self test
3)SOC
Input current
System
settings
PV current
Operation
mode
Load
AUX 1
AUX 2
Deep discharge
protection
Select function
Function
settings
8)
8)
Evening light
Night light
Morning light
Submenus
Generator
control
Excess energy
control
StecaLink slave
address
SET
SET
SET
SET SET
SET
SET SET
SET
1)
2)
3)
4)
5)
6)
7)
8)
System voltage
Open UART
Temperature
sensor
Device
temperature
Cable
compensation
Available if battery type = lead acid battery. Submenus: On/Off, cycle
Equalisation
charge
duration
Boost charge
duration
Expert menu
Start boost
charge
Battery
temperature
Remaining
capacity
Operating hours
StecaLink
master menu
Add slave
device
Submenus: SOC control mode, sensor member list
7)
Temperature
compensation
Total charge /
discharge current
of battery
Total discharge
current of battery
Total charge
current of battery
Factory reset
Change slave
Delete slave
Timer 1
Timer 4
Submenus for displaying the stored energy, current and voltage, configuration of sensors
Submenus: Datalogger On/Off, load parameter, store parameter
1)
Measurements of registered StecaLink slaves (if available)
Submenus: Float charging, boost charging, equalisation charging (available if battery type = Lead acid battery)
Submenus: On/Off, temperature coefficient
Same menus as Load, additionally with Alarm
Alarm 9)
)
9)
Only for AUX 1 and AUX 2