Chapter 4 Wiring of Inverter
Shanghai Sigriner STEP Electric Co., Ltd.
- 26 -
Figure 3-5 Mode of parallel standard installation for multiple inverters
When EP6/EH6 and ET6 are equipped with the built-in C2 filter, a spacing of 50 mm shall be
reserved between drivers as heat dissipation space
3.2.2.3 Installation method：
1. Intra-cabinet installation: The bottom of the inverter is installed on the back of the cabinet;
2. Mode of middle installation: The inverter radiator section is installed outside the cabinet
Diagram of installation inside the control
cabinet
Diagram of external installation of radiator
Installation surface of
inverter
To Next Page
Loading...