Chapter 5 Debugging and Test
Run
Shanghai Sigriner STEP Electric Co., Ltd.
- 54 -
Operation panel ▲, ▼ setting;
Terminal setting;
Communication setting;
Analog voltage and current setting.
5.1.3 Inverter operating status
The working status is divided into shutdown status and running status. Stop state: After the power-on
initialization of the inverter, if there is no operation command input, or after the execution of the
shutdown command during operation, the inverter will enter the shutdown state.
Running state: After receiving the running command, the inverter enters the running state.
5.1.4 Inverter operation mode
Closed-loop operation: The closed-loop selection function is effective (P51.00=1), the inverter will
enter the closed-loop operation mode, i.e. PID adjustment according to the setting and feedback
amount (see function code group P51).
Multi-segment speed operation: Multi-segment frequency 0~7 (P41.00~P41.15) is selected for
multi-segment speed operation by opening/closing multi-function terminals (function 3, 4, 5).
Normal operation: that is, simple open-loop operation mode.
5.2 Operation guide
The operator is the basic tool for inverter operation. It can be used to observe various status and error
codes of the inverter, and also set and view various parameters of the inverter. This section describes
the basic operation of the operator.
Users can use the panel to:
Monitor motor status
Conduct motor self-rectification
Control motor operation (motor start/stop, motor speed, forward/reverse rotation, etc.)
View and respond to errors or alarms
Set and modify parameters
Switch between local mode and remote mode
To Next Page
Loading...