STEP ET Series - Operation Status of the Operator

To Next Page

To Previous Page

Chapter 5 Debugging and Test Run

ET/EP/EH Series Intelligent Flexible Driver Manual

- 57 -

5.3.5 Operation status of the operator

There are seven operating statues for the operator. These seven statues are [Monitoring Settings],

[Debugging Wizard], [Parameter Group], [Parameter Processing], [Fault Record], [Self Learning],

and [System Settings] respectively. In any monitoring status interface, pressing can enter the

function selection interface

5.3.5.1 [Monitoring Settings] status details

The [Monitoring Settings] status of the operator is used to modify the monitoring data, supporting

two modes of standard monitoring and waveform monitoring.

In standard monitoring mode, 8 displayed data can be custom modified; in the waveform monitoring

mode, the curve of preset speed and feedback speed can be displayed in real-time in the form of

waveforms.

5.3.5.2 [Debugging Wizard] status details

Debugging wizard is a fast parameter setting mode, where includes common parameters. Guided by

this parameter, the inverter parameters can be quickly set according to the motor nameplate,

achieving rapid completion of basic debugging work.

5.3.5.3 [Parameter Group] status details

The [Parameter Group] status of the operator is used to modify parameters. See Chapter 6 for the

setting range of parameters.

In the [Parameter Group] status, press or to select parameters. Press to return

to the higher-level menu, and press or to enter parameter settings. After selecting the

parameter to be modified and pressing , and a cursor indicating the modification bit will be

added to the parameter bit to be modified. The modification bit can be changed by pressing

or to move the cursor. The parameter value can be modified by pressing or

for addition and subtraction. The key should be pressed to confirm that the modification is

valid. If is not pressed, the modification of the parameter will be invalid.

Press to return to the previous menu state.

5.3.5.4 Details of [Parameter Processing] status

In the [Parameter Processing] statues, parameters can be uploaded, downloaded, and reset. The

operator can store 4 groups of uploaded parameters.