Chapter 4 Wiring of Inverter
ET/EP/EH Series Intelligent Flexible Driver Manual
- 35 -
It is recommended that users use cables with symmetrical PE conductors that meet CE or C-Tick
standards.
Grounding
The recommended values for the cross-sectional area of the grounding conduits refer to Table 4-13
in Section 4.3.4.1.
4.2 Inverter terminal wiring
The internal view of the inverter is shown in Figure 4-6.
Figure 4-6 Internal view of inverter
Note: The terminals of inverters at each power level are the same except that the position and layout
of the power input/output terminals are slightly different. The diagram is based on an example of 11
kW.
To Next Page
Loading...