Operation & Service Manual (VA) 52 ST1175
7.2 When you carry out maintenance
Be aware that:
If you are in any doubt whether you should perform an action, please contact
your local Stertil service department or distributor.
If you are allowed to perform an action but are unsure whether you have the
ability to do so, please contact your local Stertil service department or
distributor.
Always observe the safety procedures when carrying out maintenance; see
chapter Safety (on page 15).
After carrying out the maintenance, always perform the final checks.
7.2.1 Recommendations for maintenance
When performing maintenance on your vehicle lift, keep in mind the following
recommendations:
Keep the vehicle lift clean at all times.
Repair damaged or worn parts promptly.
Ensure that all fasteners are secured after maintenance.
Do not attempt to operate defective equipment.
Follow the safety instructions in this manual.
Follow the safety regulations that apply to your site.
For repairs and maintenance, always use original Stertil parts.
7.2.2 Preparations before inspection and maintenance
Always lower the column lifts completely and switch off the main power switch
(position 0) during inspection and maintenance. Do this by turning the main switch
to the 0 position, then pull the mains plug from the socket.
The power may only be switched on temporarily for bringing the lifting system in
another position when required for performing certain checks and adjustments.
When the column lifts are in a raised position, always lower them into the safety
lock.
To Next Page
Loading...