Operation & Service Manual (VA) 56 ST1175
Per year
(technical
service)
Every 2
years
(technical
service)
Disassemble,
clean and replace
(if necessary),
and adjust; see
section Checking
the safety locking
feature.
7.6.2 Hydraulic oil
Replace the hydraulic oil in the tank approximately once every 2 years.
This oil change must take place as scheduled, even when the column lift is not
being used continuously.
When changing the hydraulic oil, proceed as follows:
1. Fully lower the column lifts and drain off the oil.
2. Fill the tank with hydraulic oil filtered at maximum 4 microns.
Hydraulic oil type
Panolin SYNTH
15 (on customers
request)
The different types of oils should not be mixed.