Instruction Manual for Libra Care Bed
Page 117
9.6 INFORMATION ON ELECTROMAGNETIC COMPATIBILITY (EMC)
To ensure electromagnetically interference-free operation, only use cables and
accessories that are approved by the manufacturer (see also chapter “Replacement
Parts” 6.3 and chapter “Accessories” 8) as replacement parts.
For the intended use as described in the main instruction manual, no significant
performance limitations during the service life of this bed are known/expected as a
result of possible electromagnetic interference from neighbouring devices.
− The use of accessories, transducers and cables other than those
supplied by the manufacturer of this bed may result in increased
electromagnetic emissions or reduced electromagnetic immunity of
the bed and may lead to incorrect operation.
− The use of this device next to other devices should be avoided, as
this could result in incorrect operation. If such use is nevertheless
necessary, this device and the other devices should be monitored to
ensure that they are working properly.
− Portable RF communication devices (radio, mobile phones etc.),
including their accessories (such as antenna cables and external
antennas) should not be used at a distance of less than 30 cm from
the electrical parts and cables of this bed. Failure to observe this
may result in a reduction in the performance of the device.
− The bed is intended for use in the electromagnetic environment
described below. The operator or user of the bed must ensure that it
is used in such an environment.
To Next Page
Loading...