• When making any adjustments to the position of the bed, always
ensure that there are no limbs belonging to residents, users, other
persons, and especially playing children, that could be trapped
underneath the rests or the bed frame.
• This bed is only intended for use as a single bed. Keep a minimum
safety distance of one bedside cabinet width (approximately 60 cm)
between one bed and the next.
• Lock the operating functions for the resident on the handset if:
- the resident is unable to operate the bed safely,
- the resident is unable to free himself or herself from potentially
dangerous situations,
- the resident is exposed to an increased risk of entrapment during
backrest and thigh rest adjustments when the safety sides are raised,
- the resident could be at risk due to unintentional motor-driven
adjustments,
- children are left unsupervised in the room with the bed.
• Each bed is delivered with a handset locking key, which is supplied in
an envelope together with this instruction manual. The locking key is
not intended to be used by the resident. The locking key should
remain with the user for safekeeping.
• Adjust the mattress base height whenever necessary, but at least
once a day, to its upper or lowest height. This automatically equalises
the two independent adjustment drives and results in a level
horizontal mattress base.
• When using accessories on electrically adjustable beds, the following
applies: Make sure that the arrangement of accessories does not
produce any crushing or shearing zones for the resident when the
back and leg rests are adjusted. If this cannot be guaranteed, the
user must safely prevent the resident from adjusting the back and
thigh rests.
• Ensure that the power cable and handset cable cannot be trapped or
damaged in any way.
To Next Page
Loading...