Instruction Manual for Libra Care Bed
Page 18
3 Putting into service
No electrical measurements are necessary prior to putting this bed into service for
the first time, since the bed has been tested by the manufacturer for electrical safety
and functionality and left our factory in perfect condition.
Before putting the bed into service for the first time:
• Remove all transport securing devices and packaging film.
• Clean and disinfect the bed.
Before putting the bed into service each time:
Check that:
- The bed has been cleaned and disinfected.
- The castors are braked.
- The power supply is compatible with the technical data of the bed (230 volt AC,
50/60 Hz).
- Easy access to the mains plug is ensured at all times so that the bed can be
disconnected from the mains, if necessary.
- The switch mode power supply unit is connected and the cable is routed in such a
way that it cannot be damaged through bed adjustments/being driven over.
- The switch mode power supply, drive cables and handset cable cannot be
damaged by the moving parts of the bed.
- This bed is not used in explosive environments caused, for example, by cleaning
agents or anaesthetics.
- Do not use this bed in combination with high-frequency surgical equipment.
- No obstacles such as bedside cabinets, supply rails or chairs will inhibit
adjustments.
- All adjustment functions are in proper working order and have been checked (see
chapter 3.1).
The care bed may be put into operation only after all these steps have been
followed!
To Next Page
Loading...