Lowering
The split safety sides can be lowered in two stages (telescopic)
Caution - danger of crushing! Be careful with fingers when adjusting and
lowering the safety side. These can be crushed between the bed frame
and the safety side!
Proceed as follows:
• First relieve the load on
the safety side by lifting it
slightly.
• Then press both release
buttons for the upper bar
1 and lower the safety
side.
• Repeat this procedure for
the middle bar (release
buttons 2 ).
4.5.6 Variant - without safety sides *
Libra beds can also be supplied without safety sides if the customer prefers.
Should it later be necessary to use a safety side, the bed can easily be fitted with this
at a later date.
The following safety side variant is available:
• Split safety side:
Please refer to chapter 4.5.4 for more information on fitting and using split safety
sides.
To Next Page
Loading...