Instruction Manual for Libra Care Bed
Page 31
4.3.2.2 Special functions
Switch the under bed light on/off * (optional)
- Standard setting: The LED under bed light is active when
connected to the mains power supply
- Press the two buttons “Backrest UP” and “Backrest
DOWN” at the same time for about 3 seconds to
manually switch the under bed light on or off.
- For more details, see chapter 4.4.2
4.3.2.3 Saving a new “intermediate stop” position
A new position can only be saved if the mattress base is in a horizontal
position.
- Adjust the mattress base to the desired minimum height.
- On the handset, simultaneously press both A buttons
briefly three times in a row
- Then immediately afterwards press button B .
As soon as the new position has been saved, a short signal tone
sounds to confirm the change.
4.3.2.4 Resetting the “intermediate stop” position to the factory default setting
- On the handset, simultaneously press both A
buttons briefly three times in a row
- Then immediately afterwards press button C for
about 5 seconds until the pulsating signal tone
stops.
To Next Page
Loading...