HLE 71, HLE 71K
English
38
Strain relief
N Make a loop in the extension
cord (3)
N Guide the loop (3) through the
opening (4)
N Guide the loop (3) over the hook (5)
and pull it tight
N Plug the extension cord into a
properly installed outlet
N Make sure you have a secure and
firm footing.
N Hold your unit with both hands –
right hand on the control handle –
left hand on the loop handle.
N Stand upright – hold the unit in a
relaxed position and always on right
side of your body.
N Make sure the cutting attachment is
not touching the ground or any other
objects.
N Press down the starting lockout
lever (1) and hold it in that position.
N Squeeze the trigger switch (2) and
hold it in that position.
N Release the trigger switch and
starting lockout lever.
WARNING
Note that the cutting attachment
continues to run for a short period after
you let go of the throttle trigger and
starting lockout lever – flywheel effect.
During longer work breaks – disconnect
the plug from the power supply.
When the machine is not in use, shut it
off so that it does not endanger others.
Secure it against unauthorized use.
Switching On
Switching Off