– Preserve the engine as specified by the en-
gine manufacturer.
– Cover the truck with a cover that is
NOT
made of plastic.
– If the truck is to be decommissioned for lon-
ger periods, contact the authorised service
centre to find out about additional meas-
ures.
Recommissioning after storage
If the truck has been in storage for longer than
six months, it must be carefully checked be-
fore being recommissioned. As in the annual
inspection, this check should also include all
safety items for the truck.
– Clean the truck thoroughly; see the chapter
entitled "Cleaning".
– Oil joints and controls.
– Check battery condition and acid density;
recharge if necessary.
– Restore engine to normal condition accord-
ing to regulations of engine manufacturer.
– Check engine oil for condensed water and
change if necessary
– Check hydraulic oil for condensation water;
change if necessary.
– Carry out the checks and tasks that are to
be performed before daily use.
– Put the truck into operation.
During commissioning, the following must be
checked in particular:
●
Drive, control, steering
●
Brakes (service brake, parking brake)
●
Lifting system (load-carrying equipment,
load chains, mounting)
NOTE
For further information, see the truck work-
shop manual or contact the authorised service
centre.
Use and operation
4
Decommissioning
98 60068011601 EN - 09/2020
To Next Page
Loading...
Need help?
General
