Change brake system liquid
ENVIRONMENT NOTE
Please handle liquids and lubricating oil in ac-
cordance with instructions.
NOTE
please contact your authorised dealer for drain
and change brake system liquid.
●
Capacity: approximately 0.3L.
CAUTION
Use a mistake and mixed with the brake liquid can
cause the brake system seal unit rusty, even to the
extent the brake out of order , serious consequences
and so on.
Fill up the hydraulic oil
– Unscrew the oil cap (1)assembly.
– Fill up with hydraulic oil through the oil inlet.
– Use the dipstick to check the oil level. The
oil level should reach the upper marking on
the dipstick.
– Close the bonnet.
– Start the engine and run it for a while.
Check the oil level again. Check the seals.
Checking the hydraulic oil level
ENVIRONMENT NOTE
Please follow the instructions for handling/
disposal of fluids and lubricants.
Maintenance
5
Maintenance service
13760068011601 EN - 09/2020
To Next Page
Loading...
