– Attach a sling (2) (able to at least bear the
weight of the forklift truck ) to the two open-
ings in the counterweight.
– Attach two shackles (5) to the two openings
in the upper beam of the outer lift mast.
– Attach a sling (3) (able to at least bear the
weight of the forklift truck ) to the two shack-
les.
– Prevent the slings from rubbing against any
sharp edges on the truck.
– Attach the ends of all the slings to the crane
hook (1).
CAUTION
After hanging the slings from the lifting hook, the
safety lock (4) must be fastened. The slings must not
touch the overhead guard or any other installed
equipment when the truck is being lifted.
DANGER
The overhead guard will be damaged if it is contac-
ted by lifting equipment that is under tension from
lifting. This can result in later failure of the over-
head guard and the risk of severe injury or death.
Ensure that no part of any lifting equipment con-
tacts the overhead guard during lifting.
Commissioning the truck
CAUTION
Do not use the forklift truck before it has been com-
missioned by a service engineer authorized by the
manufacturer.
CAUTION
The forklift truck may be commissioned only by a
service engineer authorized by the manufacturer.
Use and operation
4
Commissioning the truck
40 60068011601 EN - 09/2020
To Next Page
Loading...
Need help?
General
