Switches
Ignition device
NOTE
The forklift can only be started if the reversing
lever is in the centre position (neutral).
The ignition key has three positions:
Position "0"
●
Key removal position (no circuit powered
except for horn, stop lights; seat and ISO
PCB)
Position "Ⅰ"
●
Pre-heating position, all circuits are pow-
ered
Position "Ⅱ"
●
Engine starting position
Start-up
– To start the engine, insert the key, turn it to
position "Ⅱ" and release it as soon as the
engine starts (the key will go back to posi-
tion "Ⅰ").
Starting at cold temperature.
– Insert the key in the switch and turn it to po-
sition "Ⅰ". The pre-heater will start automati-
cally and the warning light (1) will come on.
– Wait for the warning light (1) to go out, then
turn the key to position "Ⅱ" and release it as
soon as the engine fires (the key will go
back to position "P").
OM1818
1
Use and operation
4
Switches
5960068011601 EN - 09/2020
To Next Page
Loading...
Need help?
General
