Releasing the seat belt
– Push the red button (4) on the buckle (1).
– Manually guide the belt tongue slowly back
to the retractor.
NOTE
Do not allow the seat belt to retract too quick-
ly. The automatic blocking mechanism may be
triggered if the belt tongue strikes the housing.
It will then no longer be possible to pull the
seat belt out with the usual force.
– Using increased force, pull the seat belt
around 10-15 mm out of the retractor to dis-
engage the blocking mechanism.
– Slowly allow the seat belt to retract again.
– Protect the seat belt from dirt (for example,
by covering it).
Malfunction due to cold weather condi-
tions
– If the buckle or belt retractor is frozen, thaw
them out and dry them thoroughly to pre-
vent recurrence.
CAUTION
Do not subject buckle or belt retractor to excessive
heat when thawing out.
– Do not use air warmer than 60 °C when thawing
out!
7090_342-005
1
4
Use and operation
4
Sealt belt
58 60068011601 EN - 09/2020
To Next Page
Loading...
Need help?
General
