Increasing the lifting speed
– Fully depress the brake Inching pedal (1)
and hold it down. The drive wheels are now
uncoupled from the engine.
– Pull the "lift" operating lever as far back as
possible. The truck begins to lift.
– Depress the accelerator pedal (2) to in-
crease the engine speed. This action in-
creases the lifting speed. In this way, the
lifting speed can be controlled using the ac-
celerator pedal.
Transporting loads
NOTE
Observe the information in the chapter entitled
"Safety regulations when driving".
DANGER
The higher a load is lifted, the less stable it be-
comes. The truck can tip over or the load can fall,
increasing the risk of accident!
Driving with a raised load and the lift mast tilted for-
ward is not permitted.
– Only drive with the load lowered.
– Lower the load until ground clearance is reached
(not over 300 mm).
– Only drive with the lift mast tilted backwards.
6210_800-011
Use and operation
4
Handling loads
82 60068011601 EN - 09/2020
To Next Page
Loading...
Need help?
General
