EasyManuals Logo

Still RCD25 User Manual

Still RCD25
176 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
Check the brake fluid level
Turn off the power to the forklift truck.
Check the brake oil container. The brake
fluid level must be above the minimum
mark. Unscrew the cap of the brake oil con-
tainer and add more brake fluid as necessa-
ry to avoid brake failure. Please refer to rec-
ommendations to ensure that the correct
brake fluid is used.
NOTE
If there is a large loss of brake fluid, please
contact your authorised dealer.
DANGER
Do not allow dust to get into the brake oil container.
Even a small amount of dust may have bad effect on
normal braking.
Check the small vent hole in the brake oil container
frequently to make sure that it is not clogged with
dust.
Transmission oil level inspection
procedure
NOTE
Check the transmission level with the trans-
mission in neutral, the oil hot (at least 40°C)
and with the truck on level ground.
Ensure the forklift truck is stopped on a lev-
el surface.
Remove the bottom plate.
Run the truck in neutral for 3-5 minutes.
Take out the dipstick(1)and wipe with a
clean cloth.
Fully reinsert the dipstick.
Take out the dipstick. The oil level should
be between the upper and lower marks on
the dipstick scale. If necessary, add trans-
mission oil via the oil inlet.
Fully reinsert the dipstick.
Use and operation
4
Remaining ready for operation
4960068011601 EN - 09/2020

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Still RCD25 and is the answer not in the manual?

Still RCD25 Specifications

General IconGeneral
BrandStill
ModelRCD25
CategoryTrucks
LanguageEnglish

Related product manuals