Still RX70-40 - Page 264

Message text /
Error code
Comment
DRIVE
A5041
Temperature sensor fault
Notify your authorised service centre.
BRAKE SENSOR
A3016
A3017
Sensor fault; truck can only be driven at emergency mode
speed.
Notify your authorised service centre.
BRAKE SENSOR
A3035
Brake fluid level too low or switch defective; truck can only
be driven at the emergency mode speed.
Notify your authorised service centre.
ACCELERATOR
A3002
A3003
A3004
A3005
A3006
A3007
A3505
Sensor fault, truck cannot be driven.
Notify your authorised service centre.
ACCELERATOR
A3008
Accelerator voltages (for dual pedal) do not match; truck
cannot be driven.
Notify your authorised service centre.
ACCELERATOR
A3811
Accelerator configuration is invalid. Truck cannot be driven.
Notify your authorised service centre.
DRIVE DIRECTION
A3020
Switch error; no or limited drive unit function.
Notify your authorised service centre.
VERTICAL MAST ERROR
A3135
No hydraulic function.
Turn off "vertical lift mast position".
Notify your authorised service centre.
LIFTING
A3102
A3103
Sensor fault; no or limited hydraulic drive function.
Notify your authorised service centre.
CONFIGURATION
A2111
Parametrisation error or defective printed circuit board; drive
unit and hydraulic drive not functioning.
Notify your authorised service centre.
CONFIGURATION
A3801
Parametrisation error; drive unit and hydraulic drive not func-
tioning.
Notify your authorised service centre.
CONFIGURATION
A3812
Drive programme parameters are outside the permitted
range. The drive programme parameters are limited internal-
ly.
Notify your authorised service centre.
COOLANT LEVEL
A5611
Fan is not running.
Cooling fluid level too low; check cooling fluid level and top
up if necessary.
If this does not resolve the problem, contact your authorised
service centre.
Operation
4
Display messages
252 57348011850 EN - 08/2020 - 12