Still RX70-40 - Page 265

Message text /
Error code
Comment
STEERING
A3215
Sensor fault; truck moves at emergency mode speed.
Notify your authorised service centre.
ALTERNATOR
A5811
Starter battery is not charged.
Notify your authorised service centre.
LPG AUTO. VALVE
A5670
Automatic shut-off valve does not close.
Manually close shut-off valve on LPG cylinder/LPG tank.
Notify your authorised service centre.
AIR FILTER
A5651
Depending on the design of the air filter, replace the filter in-
sert or the filter cartridges. If this does not resolve the prob-
lem, contact your authorised service centre.
VERTICAL MAST
A3130
A3131
A3132
No hydraulic function.
Turn off "vertical lift mast position".
Notify your authorised service centre.
TILTING
A3107
A3108
Sensor fault; no or limited hydraulic drive function.
Notify your authorised service centre.
OIL PRESSURE
A5631
Engine faulty (no oil pressure) or sensor faulty. Engine is
switched off for protection.
Notify your authorised service centre.
SEAT SWITCH
A302
Seat switch has not been operated for approx. 8 hours.
Truck can possibly still be driven at a reduced speed and
with reduced lifting capacity.
Stand up briefly and then sit down again.
If this does not resolve the problem, contact your authorised
service centre.
CONTROL UNIT
A3305
CIO not functioning.
Notify your authorised service centre.
OVERHEATING
A5022
Traction motor(s) is/are too hot.
1st phase: regulation of acceleration and speed.
2nd phase: limitation of phase current in converter (emer-
gency driving function is retained).
The error automatically disappears as soon as the tempera-
ture is below the limit.
If the error occurs frequently, notify your authorised service
centre
SURVEILLANCE
A2801
A2802
A2808
A2809
A2810
A2815
Drive unit not functioning.
Release accelerator pedal.
If this error occurs sporadically, it can be tolerated. If the op-
erational capacity is impaired, notify your authorised service
centre.
Operation
4
Display messages
25357348011850 EN - 08/2020 - 12