Stratasys Objet350 - Page 148

Objet350 User Guide 6 Operating and Maintaining the Objet350 3DPrinter
DOC-17001 Rev.G 6-17
Toselecttheslotsforthecartridgesmanually:
1. IntheMaterial Replacement Optionsscreen,clickAdvancedSettings.
2. IntheAdvanced Settingsscreen,selectManualslotselection,andclick
Apply.

Figure6-13Manualslotselection
3. IntheMaterial Replacement Optionsscreen,selectorcleartheBoth
cartridgescheckboxforeachslot,asrequired.
Figure6-14MaterialReplacementOptions(Advanced)
4. Whenacheckboxiscleared,adropdownmenuappears.SelectL(left)or
R(right)tochangethecartridgeontheleft ortheright sideonly inthat
location.