Stratasys Objet350 - Page 190

Objet350 User Guide 6 Operating and Maintaining the Objet350 3DPrinter
DOC-17001 Rev.G 6-59
23.Inthenextwizardscreen,confirmthatyouhaveremovedalltoolsand
objectsfromtheprinter.
Figure6-83Cleared-trayconfirmationscreen
24.Closetheprintercover.
Thewizardcontinuesbyheatingtheheads,thenfillingandpurgingthem.
Iftherearenoinstallationproblems,theoptimizationprocedurebegins,
tocalibratetheprintheadstothebestworkingconfiguration—
"Optimizing(Calibrating)PrintHeads"onpage6-43.
Ifinstallationproblemsaredetected,thewizardalertsyouandinstructs
youhowtocontinue(see"InstallationProblems",next).
25.Afterreplacingprintheads,youshouldchecktheheadalignmentbefore
usingtheprintertoproducemodels.Inthefinalwizardscreen:
❒ SelectOptimizeallprintheadsandclickNext.RuntheHeadAlignment
wizard.
Figure6-84FinalwizardScreen