Stratasys Objet350 - Page 189

Objet350 User Guide 6 Operating and Maintaining the Objet350 3DPrinter
DOC-17001 Rev.G 6-58
20.IntheReplace print heads screen,selectthecheckboxtoconfirmthat
youhavereplacedthehead(s),andclickNext.
Figure6-80Headreplacementconfirmation
21.Withyourfingers,makesurethatthenewheadislevelandevenwiththe
otherheads.

Figure6-81Checkingthelevelofthenewhead
22.Confirmthattheheadsarelevelbyselectingthecheckboxinthe
followingwizardscreen,andclickNext.

Figure6-82Installation-checkscreen