Stratasys Objet350 - Page 32

Objet350 User Guide 4 Installing Objet Studio
DOC-17001 Rev.G 4-4
7. IntheSelect Installation Folder screen,verifythedestinationfolderand
clickNext.
Itisrecommendedthatyoudonotchangethedefaultdestinationfolder.
ClickDisk Spacetocheckthespaceinthedestinationfolder.
Figure4-4ObjetStudioinstallation-folderselection
8. IntheConfirm Installation screen,clickNexttobegininstallation.
9. IntheSelect Printer Typescreen,selectthe3Dprinterusedforproducing
modelsandclickNext.
Figure4-5Printerselection