Struers LaboPol-60 - Installation; Operating LaboDoser-10; Changing Lubricant;Suspension

Procedure
Note
This does not apply to LaboForce-100.
1. Use the bracket and the two screws to mount the
dosing arm on the column of the machine.
2. Attach the bottle cap with adjustable valve onto a
Struers suspension/lubricant bottle. For 500 ml
bottles, remove the lower part of the tube.
3. Insert the bottle into the doser arm.
A suspension/lubricant bottle
B Suction tube
C Doser arm
D Adjustable valve
E Dosing nozzle
LaboDoser-10 with LaboForce-100
A table stand (optional) is required for using LaboDoser-
10 with LaboForce-100.
10.4 Operating LaboDoser-10
The operator adjusts a valve to deliver the required amount of suspension or lubricant on the
preparation disc.
1. Place the dosing nozzle in the optimal position over the preparation disc.
2. Open the valve and adjust the suspension/lubricant dosing level.
3. When the preparation step has been completed, close the valve to stop dosing.
10.5 Changing lubricant/suspension
Struersrecommends using a separate bottle cap for each consumable.
To use the bottle cap with another consumable:
1. Remove the bottle.
2. Hold the bottle firmly and remove the bottle cap.
10 LaboDoser-10
LaboPol-60 75