14.6.2 Diagrams - equipment units
For diagrams covering the individual units of equipment, see the specific equipment manual.
14.7 Legal and regulatory information
FCC notice
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
15 Pre-installation checklist
15.1 Installation requirements
Accessories and consumables
• Control panel (one of the following):
– LaboUI
– LaboForce-50
– LaboForce-100
– LaboForce-Mi
• Required accessories and consumables that have been ordered separately.
The use of Struers consumables is recommended.
Other products may contain aggressive solvents, which dissolve e.g. rubber seals. The
warranty may not cover damaged machine parts (e.g. seals and tubes), where the damage
can be directly related to the use of consumables not supplied by Struers.
For information about the available range, see:
15 Pre-installation checklist
LaboPol-60 99
To Next Page