Note
Replacement of safety critical components must only be performed by a Struers
engineer or a qualified technician (electromechanical, electronic, mechanical,
pneumatic, etc.).
Note
Safety critical components must only be replaced by components with at least the
same safety level.
12.7 Service and repair
Struers recommends that a regular service check be carried out yearly or after every 1500 hours
of use.
When the machine is started up, the display shows information about total operation time and the
machines service information.
After 1500 hours of operation time, the display will show a message reminding the user that a
service check should be scheduled.
Note
Service must only be performed by a Struers engineer or a qualified technician
(electromechanical, electronic, mechanical, pneumatic, etc.).
Contact Struers Service.
Service check
Struers offers a range of comprehensive maintenance plans to suit the requirements of our
customers. This range of services is called ServiceGuard.
The maintenance plans include equipment inspection, replacement of wear parts,
adjustments/calibration for optimal operation, and a final functional test.
12.7.1 Service check - LaboForce-100
Information about total operation time and servicing of the machine is displayed on the screen at
start-up.
After 1,500 hours of operation time, a pop-up message will appear to alert the operator that the
recommended service interval has been exceeded.
• Contact Struers Service.
Service information
LaboForce-100 provides extensive information about the condition of the various components.
Hint
The service information menus and screens are in English only.
Use the names and terms shown on the screen when you communicate with your
local service technician or Struers Service.
Service information is read-only information. Machine settings cannot be changed or modified.
• From the Main menu select Maintenance > Service functions.
12 Maintenance and service - LaboPol-60
LaboPol-60 85
To Next Page