Button Function
Start
• Starts the preparation process.
Stop
• Stops the preparation process.
Escape
• Press this button to return to the previous screen or to cancel
functions/changes.
A Turn/push knob
knob
The Turn/push knob knob
• Turn the Turn/push knob knob to move the focus on the screen
and change steps and setting. Press to toggle when only 2 options
are available.
• Press the Turn/push knob knob to select a function or save a
selected setting.
8.2.2 Water tap
Applying water automatically
Water is applied when a process is running.
• During grinding, open the nozzle on the water tap to apply water.
• During polishing, close the nozzle on the water tap.
Note
Close the water tap before you start a polishing process.
For optimal results and to avoid splashing, position the water tap between the center and the left
edge of the polishing disc.
Applying water manually
• To start applying water, press the Water button and open the water tap.
• To stop applying water, press the Water button or close the water tap.
8.2.3 The Spin function
Only use the spin function to rotate the preparation disc at high speed
• to remove water from the surface of the disc.
• to remove water from an MD-Disc or a SiC Foil/SiC Paper before you remove it,
• to dry an MD-Disc or an MD-Chem cloth
50 LaboPol-60
8 LaboForce-100
To Next Page