Struers LaboPol-60 - LaboDoser-100; Front View; Rear View

3. Empty the bottle and fill it with a mild soap solution.
4. Open the valve and clean the tube.
5. Exchange the soap water with clean water and repeat the above procedure.
6. Put the bottle cap on a Struerslubricant/suspension bottle.
11 LaboDoser-100
Front view
A Dosing block with nozzles
B LaboDoser-100
C Emergency stop(on LaboPol)
Rear view
A Label showing numbered connections
B Connections for long pump tubes
C Type plate
D Electrical cable supplying power to the
pumps
E LaboDoser-100
F Short pump tubes
G Pumps
11.1 Installation
11.1.1 Unpacking
Note
Struers recommends that all original packaging and fittings are kept for future use.
76 LaboPol-60
11 LaboDoser-100