Machine manual STYLE 350 – 510 V4.9
3.7 Switches and encoders
3.7.1 Switches
To guarantee the safety of the machine, several switches are used in the machine. The most important safety
switches are:
• Door interlock
• Microwitch chuckguard
• Limit switch X/Z axis and tailstock.
If one of these switches do not work properly the machine safety cannot be guaranteed
and it is forbidden to operate the machine.
3.7.2 Encoders
To provide the machine of the correct information several encoders are mounted. The most important encoders
are:
• Encoder S-X & Z motor
• Encoder main spindle
If one of the above mentioned sensors do not work properly, the machine will not be able function proper. The
software will detect an error in this case. May the software detect this error refer to the section trouble shooting or
contact your dealer or the department customer support of STYLE CNC Machines.
If one of these encoders do not work properly the machine safety cannot be
guaranteed and it is forbidden to operate the machine.
To Next Page
Loading...