The chuck is bolted to the spindle and secured with camlocks. Before mounting the chuck, all parts need to be
cleaned thoroughly. When a new chuck is mounted, it may be necessary to adjust the camlock studs so they line
up with the camlocks properly. To adjust, unscrew the hex-bolts and screw the studs in or out until the rear of the
chuck lines up with the groove of the stud and the notch lines up with hex-locking bolt. Then install and tighten the
hex locking bolt.
Mount the chuck on the spindle and install and tighten the 6 camlocks. When the bolts are tightened, the indicator
line on the bolt head should be positioned between the V-marks on the spindle. When one of these bolts does not
line up, remove the chuck again and adjust the camlock stud according to the instructions given in the table.
Picture 1: indicator camlock is between V-marks, adjusted correctly.
Picture 2: indicator camlock is above V-marks, screw in camlock stud one turn.
Picture 3: indicator camlock is below V-marks, screw out camlock stud one turn.
A mark should be placed on chuck and spindle to make sure that every correctly adjusted chuck is mounted on the
same position as it is was adjusted on.
To Next Page
Loading...