STYLE 350 - Page 39

Machine manual STYLE 350 – 510 V4.9
39
Re-fit motor to top of case.
IMPORTANT! Fit new Nyloc motor
mounting nuts and tighten to 8Nm.
Ensure bush, shaft and drum hub
are clean and free from debris
before re-fitting drum. Tighten drum
bush (20Nm S Series or 8Nm FX
Series)
Fit new seal.
Check inlet grille is clear.
Re-assemble unit.
IMPORTANT! Ensure safety latch
and clip are securely fastened.
Clean the swarf arrestor (where
fitted).
Check oil return hose for damage or
blockage.
Check afterfilter (if fitted) and replace
as necessary.