SP(H4SO)-3
SPEED CONTROL SYSTEMS
General Description
2. RHD MODEL
C: CAUTION
• Wear work clothing, including a cap, protective
goggles, and protective shoes during operation.
• Remove contamination, including dirt and corro-
sion, before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly, and replacement.
• Be careful not to burn your hands, because each
part in the vehicle is hot after running.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or rigid racks at the specified
points.
• Before disconnecting electrical connectors of
sensors or units, be sure to disconnect the ground
cable from battery.
(1) Accelerator bracket (6) Spring pin (11) Kick-down switch (AT model)
(2) Stopper (7) Accelerator spring
(3) Accelerator pedal lever (8) Bushing Tightening torque: N·m (kgf-m, ft-lb)
(4) Accelerator pedal spring (9) Clip T1: 12 (1.2, 9.0)
(5) Accelerator pedal (10) Accelerator stopper T2: 18 (1.8, 13.0)
SP-00022
(1)
(2)
(3)
(11)
(8)
(7)
(9)
(6)
(4)
(5)
(10)
T1
T2
To Next Page
Loading...
