108 Sun Fire X4170, X4270, and X4275 Servers Installation Guide • December 2009
Configuring the Preinstalled
OpenSolaris Operating System
Note – Before you perform this procedure, you need to set up the service processor.
If you have not done so, see “Connecting to the ILOM Service Processor for the First
Time” on page 78.
Use the information that you gathered in “Installation Worksheet” on page 104 as
you perform the configuration.
After configuring the server ILOM service processor (SP), you can configure the
preinstalled OpenSolaris Operating System (OS) over the network using Secure Shell
(SSH) or locally using the SER MGT port to connect to the system console.
Configuration instructions, see the following topics:
■ “Accessing the System Over the Network” on page 108
■ “Accessing the System Locally” on page 109
■ “Configure the Preinstalled OpenSolaris Operating System” on page 110
■ “(Optional) Redirect the Console Output to the Video Port” on page 111
▼ Accessing the System Over the Network
1. Log in to ILOM:
a. In a networked terminal window, enter ssh root@<IP_address>
Where <IP_address> is internet address of the server in the format
xxx.xxx.xxx.xxx.
b. At the password prompt, enter the default password changeme.
ILOM displays a default command prompt (
->), indicating that you have
successfully logged in to ILOM.
To Next Page
Loading...
