121
CHAPTER
7
If You Need Help
This chapter describes troubleshooting information and how to apply and remove
AC power to the server. Support contacts are also included.
This chapter includes the following topics:
■ “Powering On and Off the Server” on page 121
■ “Setup Troubleshooting” on page 122
■ “Contacting Support” on page 124
Powering On and Off the Server
Use the following procedures to power on and power off the server.
▼ Power On the Main Power
To apply main power for all server components:
1. Verify that the power cord has been connected and that standby power is on.
In standby power mode, the Power/OK LED on the front panel blinks.
2. Use a stylus, pen, or other nonconducting pointed object, to press and release
the recessed Power button on the server front panel.
When main power is applied to the server, the green Power/OK LED next to the
Power button begins to blink slowly while the system boots and lights solidly
once the operating system boots. (See
FIGURE 4-3, FIGURE 4-4, and FIGURE 4-5.)
The first time the server powers on, the power-on self-test (POST) can take up to
one minute to complete.
To Next Page
Loading...
