Chapter 6 Configuring the Preinstalled OpenSolaris Operating System 109
2. Verify that the communication properties of the service processor are set to the
defaults.
For example:
Note – The speed must 9600. You can change the speed to 9600 using the following
command:
-> set /SP/serial/host pendingspeed=9600 commitpending=true
3. Start the serial console mode by entering the following command:
-> start /SP/console
Note – Only accounts with Administrator privileges are enabled to configure the SP.
4. When the following prompt appears, type y:
Are you sure you want to start /SP/console (y/n)? y
▼ Accessing the System Locally
1. Use a cable to connect the SER MGT port of the host server to the serial port of
the client system.
2. To access the system console, start a terminal session using one of the following
methods:
■ From a OpenSolaris client:
Type the appropriate command to start a terminal session. For example, you
can start a terminal session on an OpenSolaris console by typing:
$tip -9600 /dev/ttya
-> show /SP/serial/host
/SP/serial/host
Targets:
Properties:
commitpending = (Cannot show property)
pendingspeed = 9600
speed = 9600
Commands:
cd
show
To Next Page
Loading...
