Sungrow SG5.0RT - Page 70

60
Table 7-2 "Q(P)" Mode Parameters Explanation
PPaarraammeetteerr EExxppllaannaattiioonn RRaannggee
Q(P) Curve Select corresponding curve according to local
regulations
A, B, C
*
QP_P1 Output power at point P1 on the Q(P) mode curve
(in %)
20.0 %–100.0
%
QP_P2 Output power at point P2 on the Q(P) mode curve
(in %)
20.0 %–100.0
%
QP_P3 Output power at point P3 on the Q(P) mode curve
(in %)
20.0 %–100.0
%
QP_K1 Power factor at point P1 on the Q(P) mode curve Curve A/C:
0.800 to 1.000
Curve B: -0.600
to 0.600
QP_K2 Power factor at point P2 on the Q(P) mode curve
QP_K3 Power factor at point P3 on the Q(P) mode curve
QP_
EnterVoltage
Voltage for Q(P) function activation (in %)
100.0 %–110.0
%
QP_
ExitVoltage
Voltage for Q(P) function deactivation (in %)
90.0 %–100.0
%
QP_
ExitPower
Power for Q(P) function deactivation (in %)
1.0 %–20.0 %
QP_
EnableMode
Unconditional activation/deactivation of Q(P)
function
Yes, No
* Curve C is reserved and consistent with Curve A currently.
7 iSolarCloud App User Manual