SureShot AC320 User Manual

IntelliShot & FlexoShot: Operations Manual Page 37
Problem
Resolution
Product temperature is
too warm or too cold
Verify the following:
1. The dispenser’s refrigeration system is on. A temperature setting of
“00” means the dispenser’s refrigeration system is turned off.
2. The dispenser’s temperature setting is between 34°F to 40°F (1.1°C to
4.4°C). To adjust the temperature, refer to the Temperature Display
and Adjustment section in this manual.
3. If there is a flashing red dot on the side console display, the
dispenser’s defrost cycle is on and it is not actively cooling the
product compartment. The defrost cycle runs for approximately 20
minutes. If the cycle continues running for longer, reset the defrost
cycle by turning the dispenser off. After 10 seconds, turn it back on.
The inside walls of the product compartment should become cold
after approximately 12 minutes.
4. Excess ice has not formed inside the product compartment. If it has,
unplug the dispenser. Wipe out any ice or water with a clean, soft
cloth.
5. Product loaded in the dispenser is between 34ºF and 40ºF (1.1ºC and
4.4ºC). The fridge where the product is stored is working correctly.
6. The dispenser is not situated near a heat-generating source (e.g.,
coffee maker, heat lamp, direct sunlight).
7. There is a 1-inch (2.5 cm) of space around all sides of the dispenser.
8. The vents at the back of the dispenser are not blocked.
9. The condenser is clean.
10. The dispenser is level. It must be level for the refrigeration system to
operate correctly. Adjust dispenser legs as required.
11. The fan is operating.
12. Nothing is stored under the dispenser. The intake holes on the
underside must be unobstructed.
Excess ice or frost in
the product
compartment
Verify the following:
1. The temperature inside the product compartment is between 34ºF and
40ºF (1.1ºC and 4.4ºC).
2. The door gasket is not damaged. For the gasket to seal completely,
there should be no holes or gaps.
3. Ice has not formed inside the product compartment. Ice may
occasionally form, as the dispenser is not a frost-free system. To
remove excess ice, unplug the dispenser. After 15 minutes, the ice
should be soft enough to remove with a dry, soft cloth.
Red light is flashing on
the reset/refill button or
on a product button
A flashing red light indicates the product level is low. Product is low when
less than 40.6 oz. / 1200 ml of product remains in the dairy bag or product
tank.

SureShot AC320 Specifications

General

Brand	SureShot
Model	AC320
Category	Dispenser
Language	English