Suzuki DR650SE - Special Tools for Chassis Service

5-47 CHASSIS
LOWERING THE SEAT HEIGHT
The seat height can be lowered 40 mm by changing the lo-
cation of the inner parts of the front fork and rear shock ab-
sorber and
replace the optional side stand_
OPTIONAL PARTS SUPPLY
Part No_
Part Name
pes
Note
Non
Side stand
® (Silver painting) 1
For
E-03
09248-10006
Plug 1
E-24
42300-32820
62184-32EOO Plate 1
E-28
68380-32E 10
Label set
1
E-33
Non Side stand
@ (Silver painting) 1
09248-10006 Plug 1
42300-32810
62184-32EOO Plate 1
For
the others
68380-32EOO Label set 1
NOTE:
Side stand length @is defferent from ®in the above chart.
SPECIAL TOOLS
This special tool is used for loosening and tight-
ening the front fork damper rod bolt.
09940-34520: liT" handle
This special tool is used for adjusting the front
fork oil level.
09943- 7 4111: Front fork oil level gauge
This special tool is used with tool
(09940-34520) for loosening and tightening the
front fork damper rod bolt_
09940-34592: Attachment "G"
This special tool is used for loosening and tight-
ening the rear shock absorber ring.
09910-60611: Universal clamp wrench