Suzuki DR650SE - Page 165

• Tighten the front fork lower clamp bolts and fork cap bolt
to the specified torque.
• Tighten the front fork upper clamp bolt to the specified
torque.
~ Front fork cap bolt: 23 N·m (2.3 kg-m, 16.5 Ib-ft)
Upper clamp bolt : 29 N·m (2.9 kg-m, 21.0 Ib-ft)
Lower clamp bolt : 26 N·m (2.6 kg-m, 19.0 Ib-ft)
• Install the brake hose clamp and speedometer cable guide
correctly.
• Tighten the front brake caliper mounting bolts to the speci-
fied torque.
~ Brake caliper mounting bolt: 26 N·m
(2.6 kg-m, 19.0 Ib-ft)
• Align the drive lugs CD with the recesses @ of the wheel
hub.
• Before tightening the front axle, position the stopper @
of the speedometer gearbox against stopper @.
• Tighten the front axle to the specified torque and then
move the front fork up and down.
• Tighten the upper axle holder nuts first and then lower
nuts to the specified torque.
~ Front axle: 65 N·m (6.5 kg-m, 47.0 Ib-ft)
Axle holder nut: 10 N·m (1.0 kg-m, 7.0 Ib-ft)
CHASSIS 5·52