Suzuki DR650SE - Page 52

3·15 ENGINE
• Remove the crancase securing bolts.
• Separate the crankcase into 2 parts, right and left with
the crankcase separating tools .
• ¥u 09920-13120: Crankcase separating tool
09910-33210: Crankshaft installer attachment
NOTE:
Fit the crankcase separating tool, so that the tool plate is
parallel with the end face of the crankcase.
I A. CAUTION I
The crankshaft and transmission components must re-
main in the right crankcase half. This is necessary be-
cause
the gearshift cam stopper is mounted on the right
crankcase half and will be damaged if the transmission
components remain in the left half.
• Remove the gearshift cam stopper.
• Remove the gearshift fork shafts and gearshift forks.
• Remove the gearshift cam.
• Remove the driveshaft assembly and countershaft as-
sembly_