Suzuki kq500 - IAP; TP; IAT Sensor Removal and; ECT Sensor Removal and Installation

Engine Electrical Devices: 1C-2
CKP Sensor Removal and Installation
B931H21306003
Removal
1) Remove the generator cover. Refer to “Generator
Removal and Installation: in Section 1J”.
2) Remove the CKP sensor (1) along with generator
stator.
Installation
Install the CKP sensor in the reverse order of removal.
Refer to “Generator Removal and Installation: in
Section 1J”.
IAP / TP / IAT Sensor Inspection
B931H21306004
Refer to “DTC “C13” (P0105-H/L): IAP Sensor Circuit
Malfunction: in Section 1A”, “DTC “C14” (P0120-H/
L): TP Sensor Circuit Malfunction: in Section 1A”
and “DTC “C21” (P0110-H/L): IAT Sensor Circuit
Malfunction: in Section 1A”.
NOTE
IAP sensor, TP sensor and IAT sensor are
combined into one.
IAP / TP / IAT Sensor Removal and Installation
B931H21306005
Refer to “Throttle Body Disassembly and Assembly:
in Section 1D”.
CAUTION
!
• Never remove the IAP/TP/IAT sensor from
the throttle body.
• The IAP/TP/IAT sensor and throttle body
are available only as an assembly.
ECT Sensor Removal and Installation
B931H21306006
Removal
1) Drain engine coolant. Refer to “Cooling System
Inspection: in Section 0B”.
2) Remove the right side cover. Refer to “Front Side
Exterior Parts Removal and Installation: in
Section 9D”.
3) Disconnect the coupler (1) and remove the ECT
sensor (2).
CAUTION
!
Take special care when handling the ECT
sensor. It may cause damage if it gets an
excessive impact.
Installation
Install the ECT sensor in the reverse order of removal.
Pay attention to the following points:
• Tighten the ECT sensor to the specified torque.
CAUTION
!
Use the new gasket washer (1) to prevent
engine coolant leakage.
Tightening torque
ECT sensor (a): 18 N·m (1.8 kgf-m, 13.0 lbf-ft)
• Pour engine coolant. Refer to “Cooling System
Inspection: in Section 0B”.
1
I931H1130002-01
1
2
I931H1130003-01
(a)
1
I931H1130004-01