Front Suspension: 2B-12
• Install the snap ring (2) with the special tool.
CAUTION
!
Replace the snap ring (2) with a new one.
Special tool
: 09900–06107 (Snap ring remover (Open
type))
Lower
• Install the knuckle end (1) with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set (10 –
75))
• Install the snap ring (2) with the special tool.
CAUTION
!
Replace the snap ring (2) with a new one.
Special tool
: 09900–06107 (Snap ring remover (Open
type))
Front Suspension Arm Related Parts Inspection
B931H22206013
Refer to “Front Suspension Upper / Lower Arm Removal
and Installation (Page 2B-9)”.
Upper arm
1) Inspect the following parts for wear or damage. If any
defects are found, replace defective parts with new
ones.
• Upper arm (1)
• Dust seal (2)
• Washer (3)
• Spacer (4)
2) Insert the spacer into bushings.
3) Check the play by moving the spacer up and down. If
excessive play is noted, replace the bushing with a
new one. Refer to “Front Suspension Upper Arm
Bushing and Inner Dust Seal Removal and
Installation (Page 2B-13)”.
2
I931H1220040-01
1
(A)
I931H1220041-01
2
I931H1220042-01
1
2
2
3
3
4
I931H1220043-01
I931H1220044-01
To Next Page
Loading...
