Suzuki kq500 - Page 503

Automatic Transmission: 5A-19
Assembly
• Install the bearing (1) with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set (10 –
75))
CAUTION
!
The removed bearing must be replaced with a
new one.
• Fit the bearing retainers (2).
• Apply a small quantity of thread lock to the bearing
retainer screws (3), and tighten them securely.
: Thread lock cement 99000–32030
(THREAD LOCK CEMENT SUPER 1303 or
equivalent)
• Install the oil seal (4) with the special tool.
CAUTION
!
The removed oil seal (4) must be replaced
with a new one.
Special tool
(A): 09913–70210 (Bearing installer set (10 –
75))
• Apply grease to the lip of the oil seal (4).
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the spacer (5).
CAUTION
!
Replace a O-ring (6) with a new one.
• Apply grease to the O-ring (6).
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the clutch housing (7).
(A)(A)
1
I931H1510076-01
2
3
3
I931H1510077-01
(A)
4
I931H1510079-01
6
5
I931H1510078-01
7
I931H1510080-01