Suzuki RM-Z250 - Page 175

DISASSEMBLY AND ASSEMBLY 4-95
• Set the “ ” mark on the handlebar holder 9 forward.
• Align the matching mark B on the handlebars with the match-
ing surface of the handlebar holder 9.
• Tighten the handlebar clamp bolts 0 to the specified torque.
NOTE:
When tightening the handlebar clamp bolts 0, first tighten the
bolts C.
 Handlebar clamp bolt: 25 N·m (2.5 kgf-m, 18.0 lbf-ft)
• Tighten the handlebar holder set nuts A to the specified
torque.
 Handlebar holder set nut: 44 N·m (4.4 kgf-m, 32.0 lbf-ft)
• Apply grease to the throttle cable and their hole.
 99000-25010: SUZUKI SUPER GREASE “A”
or equivalent