Suzuki RMX450Z Service Manual

1K-4 Exhaust System:
Specifications
Tightening Torque Specifications
BA02J21B07001
NOTE
The specified tightening torque is described in the following.
“Exhaust System Components” (Page 1K-1)
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List” in Section 0C
(Page 0C-8).
Special Tools and Equipment
Recommended Service Material
BA02J21B08001
NOTE
Required service material is also described in the following.
“Exhaust System Components” (Page 1K-1)
Fastening part
Tightening torque
Note
N⋅mkgf-mlbf-ft
Muffler mounting bolt
23 2.3 16.5
)(Page 1K-2) /
)(Page 1K-3)
Exhaust pipe bolt/nut
23 2.3 16.5
)(Page 1K-3) /
)(Page 1K-3)
Muffler connecting bolt
19 1.9 13.5
)(Page 1K-3) /
)(Page 1K-3)
Material SUZUKI recommended product or Specification Note
Muffler seal MUFFLER SEAL LOCTITE 5920
(commercially available) or
equivalent
— )(Page 1K-3)

Suzuki RMX450Z Specifications

General

Displacement	449cc
Compression Ratio	12.5:1
Fuel System	Fuel injection
Starter	Electric
Transmission	5-speed constant mesh
Final Drive	Chain
Front Suspension	Inverted telescopic, coil spring, oil damped
Rear Suspension	Link type, coil spring, oil damped
Engine Type	4-stroke, liquid-cooled, DOHC
Bore x Stroke	96.0 mm x 62.1 mm
Front Brakes	Single disc
Rear Brakes	Single disc
Front Tire	80/100-21
Fuel Tank Capacity	6.2 L (1.6 US gal)
Overall Length	2185 mm (86.0 in)
Ground Clearance	325mm
Seat Height	955mm
Wheelbase	1, 480mm